New Trasdata and FLEX: Bench and Boot Reading Basics for Modern ECUs
FLEX from Magicmotorsport and New Trasdata from Dimsport are the two bench tools behind a large part of our catalogue: FLEX reads and New Trasdata reads together account for thousands of listings. Both handle bench and boot mode on Bosch, Continental, Denso, Delphi and Marelli units. This guide explains how they work and what to expect from their files.
Bench mode
The ECU is connected on the desk through its main connector. The tool supplies power, wakes the unit in a service mode and reads the memory through CAN. No case opening, no soldering. FLEX and New Trasdata publish pinout diagrams per ECU model; wiring is done with a bench harness or individual probes. Bench mode reads the full flash and, on Tricore units, the dataflash where immobilizer data is stored.
Boot mode
The case is opened and the tool connects to the processor’s boot pins with a probe adapter, forcing the microcontroller into its boot loader. Boot mode works even when the ECU has no valid firmware, which makes it the recovery method for bricked units, and it is required for locked processors that refuse bench access. Both tools provide adapters and positioning frames for common Tricore, MPC and SH boards.
What the two tools cover
- Bosch EDC17 / MED17: full bench support including protected versions such as EDC17C46, EDC17C64, MED17.5.21.
- Bosch EDC16 / ME7 / MED9: bench and BDM/boot.
- Bosch MG1 / MD1 (MD1CS003, MD1CS006): bench with password handling.
- Continental SID/SIM/SIMOS (SID807EVO, SID208), Delphi DCM, Marelli MJD/IAW, Denso.
- Gearbox TCUs (DQ200, DQ250, ZF 8HP).
Reading procedure
- Identify the ECU model in the tool’s database and follow its wiring diagram.
- Power from a regulated 12 to 14 V supply; keep the laptop on mains.
- Let the tool identify the unit and compare the numbers with the label.
- Read the full memory and save the file with the software number in the name. Read twice if the tool offers verification.
Checksums and writing
Both tools correct checksums when writing modified calibrations. When writing a complete original file for recovery, no correction is needed because the image is already consistent. Always verify after writing and read back the identification.
Using our files with these tools
A file read with FLEX or New Trasdata is a full memory image and can be written back with the same tool or with another bench tool that supports the ECU (KTAG, PCM Flash). Format differences between tools concern the file container, not the data; if your tool asks for a specific format, contact us and we will convert it. Missing your version? Use the file request form.
More ECU guides
Airbag Crash Data Clear: How to Reset an SRS Module with a Dump
After an accident in which the airbags or pretensioners fired, the SRS control module stores crash data and refuses to work again, even after every airbag…
KESS V2 vs KTAG: Which Tool for Which ECU?
KESS V2 and KTAG come from the same manufacturer (Alientech) and are often bought together, but they do different jobs. KESS talks to the ECU through…
BMW and Mini CAS3 ELV Off Dump: E90, E60, X1 E84 and R56 Steering Lock Fault Fix
The customer turns the key, the dash shows a yellow steering lock symbol with a message about the steering lock, and nothing cranks. On an E90…